WOODFORD WF-30MS MODEL 30 WALL FAUCETS MOUNTING SLEEVE INLET

WOODFORD WF-30MS MODEL 30 WALL FAUCETS MOUNTING SLEEVE INLET
WOODFORD WF-30MS MODEL 30 WALL FAUCETS MOUNTING SLEEVE INLET
Quantity Price
1 to 11 $19.45
12 and up $17.51
Part #WF-30MS
Woodford
WF-30MS
Model 30 Wall Faucets Mounting Sleeve Inlet
Genuine Woodford Manufacturing Product. ALL Woodford orders must meet the $25 minimum requirement to ship from their factory.

The Woodford Model 30 Wall Faucet Mounting Sleeve (WF-30MS) takes the guesswork out of how far to stub-out Woodford Model 30 freezeless faucets through brick, stone or stucco veneers. It also provides a secure anchor for the faucet. The Model 30 Mounting Sleeve allows the plumber to determine a stub-in location and set an adjustable fi nish depth required by the brick or stone mason. A numbered scale is built into the top of the Mounting Sleeve. The faucet installation is completed by mating the faucet wall fl ange to the front of the Mounting Sleeve and securing with two, furnished fl ange screws. The proper drain angle is built-in to the faucet head casting.

Includes:
1. WF-30MS Mounting Sleeve
2. Bottom Bracket
3. Top Bracket
4. Flange Screws
5. Wood Screws

WF-30MS Wall Faucet Mounting Sleeve Installation Instructions For Woodford Models 30 ONLY
1. Determine the wall surface where the Mounting Sleeve will be located. Fig 1
2. Draw a level line, center and drill a 2-9/16 hole Fig 1
3. Align the Bottom Bracket, arrows pointing up, with the hole and level line. (The Mounting Brackets can be installed on the inside wall or the outside of the wall) Fig 1
4. Use (4) of the furnished wood screws to secure the Bottom Bracket. Fig 2
5. Slide Mounting Sleeve through the hole. Use the number scale on top of the Mounting Sleeve to determine exposure distance. Fig 3
6. Slide the Top Bracket over the Mounting Sleeve and into the Bottom Bracket. Fig 4
7. Lock the Top Bracket into one of the Mounting Sleeve slots. Use the remaining wood screw to secure the Top Bracket. Fig 5

Note: If soldering to an inlet, make sure heat is far enough away from the Mounting Sleeve.