Zurn Z1170 Grease Interceptor

Zurn Z1170 Grease Interceptor. Above or below grade applications. Sizes 500-800 PDI certified.

ZURN Z1170 Acid Resistant Coated interior and exterior fabricated steel grease interceptor, PDI, rated at ____ GPM and ____ Lbs. grease capacity, with internal air relief by-pass, bronze cleanout plug, removable pressure equalizing/flow diffusing inlet baffle, fixed bottom outlet baffle, and visible double wall trap seal. Gasketed non-skid secured cover complete with center tie down assembly, with Z1108 flow control fitting. Regularly furnished with a high inlet and outlet connection. Note: Location of outlet from bottom of interceptor cannot be changed.

PREFIXES
Z Acid Resistant Coated Fabricated Steel*
ZS All Type 304 Fabricated Stainless Steel

SIZES
100
200
300
400
500
600
700
800

SUFFIXES
-AL Aluminum Cover-DI Dual High/Low Inlet.
-E Acid Resistant Coated Interior and exterior fabricated steel extension section. (Specify 'C' Dim. required) for recessed installation.
-HD Heavy Duty Cover rated at 10,000 lbs. maximum safe live load. A 3 [76] minimum extension height is required when Heavy Duty Cover (-HD) option is specified.
-K Anchor flange 1 3/4 [44] down from top and 2 [51] wide. A 3 [76] minimum extension height is required when anchor flange (-K)option is specified.
-KC Anchor flange 1 3/4 [44] down from top and 2 [51] wide with clamp collar. A 3 [76] minimum extension height is required when anchorflange (-K) option is specified.
-L Angle type (Z1108-L) flow control device with plunger
-R Acid resistant coated interior and exterior fabricated steel recessing receiver for recessed installation is equipped with adjustable support brackets and gasketed non-skid cover with covered recessed lift handle.
-RE Acid resistant coated interior and exterior fabricated steel recessing receiver enclosed type for recessed installation. Furnished with adjustable support brackets and gasketed non-skid cover with covered recessed lift handle.
-T Cover recessed for tile/terrazzo. A 3 [76] minimum extension height is required. (Specify recess depth - 1/8 [3], 3/4 [19], or 1 1/4 [32]).


*REGULARLY FURNISHED UNLESS OTHERWISE SPECIFIED
Additional freight charges apply for all Interceptors.